
Before you start make sure of the following:
- Key out of the ignition
- All doors closed
Follow the following steps to get the system ready:
- Get in the driver seat and make sure that drivers door is open and is unlocked.
- Within 5 seconds Insert the key into the ignition (Do NOT Turn) Pull key out 2 times
- Within 40 seconds Close then open the drivers door 2 times
- Within 5 seconds Insert the key into the ignition (Do NOT Turn) Pull key out 1 times
- Within 40 seconds Close then open the drivers door 2 times
- Insert the key into ignition and leave it in ignition. then Close the drivers door.
- Turn the ignition to ON (Do NOT Start) then back to OFF.
- Remove the key from the ignition.
If the locks do not cycle at this point then Return to step 1
You must perform these steps within 40 seconds to program the remote(s)
- Press the lock and unlock buttons on the remtoe simutaneously for 1.5 seconds.
- Immediately after press the lock button by itself and hold for 2 seconds.
If the door locks cycle twice, repeat the above steps as the remote was not accepted.
To complete the programming Open drivers door then close it.
Note: If your remote only unlocks but does not lock, the programming is complete but one of your doors is not fully shut.
No comments:
Post a Comment